Exhaust Pipe Removal And Installation; Exhaust Pipe Removal - Terex PT-30 Service Manual

Figure 11-5
2. From the underside, install the four muffler
mounting bolts and washers/shims as found
upon disassembly.
Figure 11-6
3. Carefully slide the curved pipe into the muffler
inlet. You may need to tap it into place with a
rubber mallet or similar device.
NOTICE
If it is necessary to tap the pipe section into the muffler, do
so carefully as the pipe walls are thin and easily distorted.
Use caution and care as you install the pipe section.
11. Engine Components Disassembly and Assembly
Install
Bolts
Figure 11-7
4. Install the muffler clamp and secure in place.
Exhaust Pipe Removal and In-
stallation
The tools required for exhaust pipe removal and in-
stallation are listed in Table 11-2. Use manufacturer-
recommended tools whenever possible.
Table 11-2
Required Tools
Socket/Combination Wrench
Pry Bar
Penetrating Lubricant
Rubber Mallet/Plastic Hammer

Exhaust Pipe Removal

The exhaust system gets very hot during opera-
tion! Allow the machine to cool thoroughly prior to
performing service on the exhaust system.
Figure 11-8
1. Loosen the nuts on the muffler clamp
11-3
Compact Track Loader
Tighten
Nuts
Loosen
Nuts