Installation; Loader Float Magnet Removal And Installation; Loader Float Magnet Removal - Terex PT-30 Service Manual

Figure 9-4
8. Pull the joystick away from the cab wall as shown.
Figure 9-5
9. The hydraulic hoses are now accessible. Label
them and the ports they connect to to aid during
reassembly, then disconnect them and cap and
plug the openings to prevent spills.
Figure 9-6
10. Disconnect the electrical connections shown to
free the joystick from the machine, then remove.
11. Reverse the removal procedure to reinstall the joy
stick. Take care to ensure all connections are to
the appropriate ports on the joystick and that they
are tight and leak free.
9. Loader/Transmission Controls
Note: If it is neccessary to remove the left joystick on a
machine equipped with a heater, you must disconnect
the heater lines at the heater unit in order to remove
the side panel. Cap and plug hoses and ports to mini-
mize coolant loss.
Loader Float Magnet Removal and

Installation

The tools required for loader float magnet removal and
installation are listed in Table 9-2. Use manufacturer
recommended tools whenever possible.
Table 9-2
Required Tools
Allen (hex) Wrenches
Combination Wrenches
Screwdriver

Loader Float Magnet Removal

Figure 9-7
1. Remove the zip tie securing the lower portion of
the joystick boot to the joystick as shown.
Remove
Figure 9-8
2. Lift the boot to expose the magnet and joystick
mounting bolts. Remove the joystick mounting
bolts to allow the joystick to be moved upward
within the bracket.
9-3
Compact Track Loader