Exhaust Pipe Installation - Terex PT-30 Service Manual

Compact Track Loader
11. Engine Components Disassembly and Assembly
Remove
Bolts
Figure 11-9
2. Remove the four bolts that secure the exhaust
pipe to the exhaust manifold.
Figure 11-10
3. Remove the exhaust pipe gasket from the ex-
haust manifold, then remove the retaining
springs and center pipe from the assembly.
Note: The gasket may come off with the exhaust pipe.
Figure 11-11
4. Spray the joint with penetrating lube, then slide
the curved pipe out of the muffler inlet. A pry bar
may be helpful in removing this pipe section.

Exhaust Pipe Installation

Figure 11-12
5. Carefully slide the curved pipe into the muffler
inlet. You may need to tap it into place with a
rubber mallet or similar device.
If it is necessary to tap the pipe section into the muffler, do
so carefully as the pipe walls are thin and easily distorted.
Use caution and care as you install the pipe section.
Figure 11-13
6. Install the center section of pipe as found upon
disassembly and install the retaining springs.
Then, position the exhaust gasket for reinstalla-
tion and start one bolt to hold it in place.
11-4
NOTICE