Table of Contents
Advertisement
Chapter 4 Operation Using ICIM
To Set Up the IP Configuration Parameters for SNMP Support using ICIM
1
Press the
2
Select the Password menu and enter the User Password. The ICIM allows
configuration changes for the next 10 minutes.
Note: Refer to your specific hardware Installation and Operation Guide for more
information on using, entering, or changing the ICIM user password.
3
Press the
4
Use the
Press the
5
Use the
6
parameter; IP Address, IP Subnet, or Gateway IP.
Press the
7
the first segment of the address is highlighted.
Enter the correct numbers for the first segment of the address.
8
Note: One of two methods can be used to enter the numbers, as follows:
Press the
Press the
Numlock On appears on the front panel LCD. Then enter the exact number
using the number keys on the 12-key numeric keypad.
9
Press the
the right. You can also use the
segment of your choice.
Note: If you are using the numeric entry mode, the cursor moves to the next
address segment to the right automatically after you enter the last digit of the
current address segment.
10 Repeat steps 8 and 9 until all address segments are entered. After you enter the
last address segment and press the Enter key, the system returns to the IP Setup
menu.
11 Repeat steps 6 through 10 for each IP Setup parameter that you need to enter.
12 Restart the ICIM.
Important: IP Setup parameters do not take effect until the ICIM is restarted.
92
key. The ICIM menu appears on the ICIM LCD.
key. The ICIM menu appears.
key to scroll down until IP Setup is highlighted.
key. The IP Setup menu appears.
or
keys to scroll to and highlight the desired configuration
key. The Adjust menu for the selected IP parameter appears, and
or
keys to increase/decrease the number to set value.
key to change to the numeric entry mode. Confirm that
key to accept your entry and move to the next address segment to
or
keys to move to the address
78-4025693-01 Rev D
Advertisement
Table of Contents
Troubleshooting
