Chapter 2 Module Installation
Preparing for Installation
Before you begin, make sure that the module is in good condition and that you have
the tools and equipment listed here.
Unpacking and Inspecting the Module
As you unpack the module, inspect it for shipping damage. Inspect the rear
connectors for bent pins.
If you find any damage, contact Cisco Services.
Equipment and Tools Needed
You need the following equipment and tools to install these modules.
You need . . .
a Prisma II Chassis with power supply
3/8-in. flat-blade screwdriver
optical cables with connectors
optical cleaning materials
optical power meter
10
To . . .
provide housing, power, and input/output
connections to the module.
secure the module in the chassis.
carry optical input and output signals.
clean optical connectors.
verify optical input and output levels.
78-4025693-01 Rev D