To Change Parameters - Cisco Prisma II Hybrid Amplifier Installation Manual

Chapter 4 Operation Using ICIM

To Change Parameters

Below is an example dialog where one of the parameters (Trap Community) is
changed. Any of the parameters can be changed, although some should be changed
only with the advice of a Cisco Services representative.
Note: Hardware parameters (serial channel baud rate, serial number, and board
Ethernet address) should not be changed.
NETWORK INTERFACE PARAMETERS:
Do you want a LAN interface?
This board's LAN IP address(0.0.0.0 = RARP)? [192.133.194.219]
Subnet mask for LAN (0 for none)? [255.255.255.0]
Should there be a default gateway for packet routing?
What is its IP address? [192.133.194.254]
SNMP COMMUNITY STRINGS:
Read Community [public]
Write Community [private]
Trap Community [SNMP_trap] ICIM_Trap
Trap Port for P2 traps [162]
HARDWARE PARAMETERS:
Baud rate for serial channels [9600]
Enter the Serial number?
HARDWARE PARAMETERS:
Do you want to change the board's Ethernet address? [N]
BOOT ROM PARAMETERS:
IP address of the TFTP Boot server to boot from? [192.133.194.4]
What is the name of the file to be loaded and started? [ram014.crc]
How long (in seconds) should CPU delay before starting up? [5]
Each time a prompt is given, the default value is displayed in square brackets.
Press Enter to retain the current value and move onto the next parameter.
1
Note: As an example in the above screen, the Trap Community string has been
changed to a new value. The prompt for delay time is the last one before the
summary screen is presented.
Press any key repeatedly until the following prompt appears.
2
(M)odify any of this or (C)ontinue? [M]
3 Press Enter to get the default value for Modify.
100
[Y]
[^AAIIJHC]
[Y]
78-4025693-01 Rev D