To Enable Optical Output - Cisco Prisma II Hybrid Amplifier Installation Manual

4 Gently slide the module into the chassis until its power and communications
connections join connectors on the Back Plane Bus. Do not force the module into the
chassis. If properly aligned, it should slide in with minimal force.
Slowly press the module ejector levers toward the chassis and confirm that the
5
jaws of the ejectors engage with the mounting flange in the chassis. When this
occurs, the ejectors act as levers that pull the module toward the mounting flange
and cause its power and communications connectors to mate fully with the
corresponding connectors at the rear of the chassis. After confirming correct
ejector operation, press both ejectors fully so that they are parallel to the module
front panel.
6 Hand-tighten the screw at the top of the module to secure it in the chassis. Use a
3/8-in. flat-blade screwdriver to secure. Do not over-tighten.
Fill any unused slots with module blanks to guarantee proper cooling air flow.
7

To Enable Optical Output

As a safety precaution, the optical output of this module is disabled by factory
default.
Complete the following steps to enable optical output after the module is installed.
1 Obtain the chassis and slot number for the module. When using Telnet for
communication with the module, also obtain the chassis IP address.
2 Use HyperTerminal, Telnet, or your network management system to establish
CLI (command line interface) communication with the module's controlling
ICIM. Once communication is established, the CLI> prompt appears onscreen.
Note: Instructions for using HyperTerminal and Telnet are provided below. For
instructions on using your network management system, see your network
administrator.
78-4025693-01 Rev D
Installing the Module in the Chassis
15