Module Configuration; Configuration And Monitoring Methods - Cisco Prisma II Hybrid Amplifier Installation Manual

Module Configuration

The module is shipped from the factory with operational parameters set to factory
defaults. However, you will probably choose to configure the operating parameters
so that they are best suited for your application.

Configuration and Monitoring Methods

The module may be controlled and monitored using one of the following methods.
The CLI software

The CLI software running locally on a PC connected to the ICIM can be used to
control and monitor the module. For instructions on operating this module using
the CLI, refer to Operation Using CLI (on page 29) and the Prisma II Platform
Remote User Interface Guide, System Release 2.03, part number 4025477.
ICIM Web Interface

The ICIM Web Interface offers a user-friendly alternative to CLI commands for
remote module setup and monitoring. Users navigate a series of HTML pages
through a standard web browser to view and, where permitted, adjust module
parameters. For additional information, see the Prisma II Platform Remote User
Interface Guide, System Release 2.03, part number 4025477.
The Prisma II ICIM Front Panel

If an ICIM is installed in the Prisma II chassis, it may be used to monitor the
Prisma II application modules within its domain. For security reasons, this non-
password protected front panel interface is limited to read-only monitoring
except that the amplifier may be placed in service mode. For instructions on
operating this module using the ICIM, refer to Operation Using ICIM (on page
63).
LCI software

The LCI software running on a locally connected PC may be used to configure
operating parameters of Prisma II modules. For instructions on operating this
module using the LCI software, refer to Operation Using LCI (on page 103).
TNCS or ROSA Remote software

TNCS or ROSA software may be used to configure and monitor all functions of
the Prisma II modules. For further information, refer to the TNCS Administrator
Release 3.0 Software User's Guide, part number 4013494 or the appropriate ROSA
software documentation.
78-4025693-01 Rev D
Module Configuration
7