Paging Command - Cisco Prisma II Hybrid Amplifier Installation Manual

Terminal Commands
CLI> terminal colsep "," exit
CLI> module modid * show control *serv* exit
CHASSIS,SLOT,NAME,SETTING,UNITS
1,7,Service,Off(0),
1,8,Service,Off(0),
1,9,ServiceA,On(1),
1,9,ServiceB,Off(0),
SUCCESS!
CLI>
If the output data itself might contain columns, another character such as | can be
used as a column separator, as shown in the following example:
CLI> terminal colsep "|" exit
CLI> module modid * show control *serv* exit
CHASSIS|SLOT|NAME|SETTING|UNITS
1|7|Service|Off(0)
1|8|Service|Off(0)
1|9|ServiceA|On(1)
1|9|ServiceB|Off(0)
SUCCESS!
CLI>

Paging Command

The paging command is used to control paging behavior for long CLI output. The
basic syntax is as follows:
paging value
where value is zero (0) to disable paging completely, or a number 24 or greater to
specify the height of the paging window in lines of text.
78-4025693-01 Rev D 57