Hybrid Amplifier Configurable Parameters; Hybrid Amplifier Alarm Data Parameters - Cisco Prisma II Hybrid Amplifier Installation Manual

Note: Monitored values may vary from module to module. The values shown above
are examples only.

Hybrid Amplifier Configurable Parameters

Parameter ICIM
Name (LCI) Abbreviation
Enable Laser Enable
Optical Power SetAtten
Attenuation
Operational Mode
Mode
Input Alarm LoInpEna
Laser Shutdown
Service Mode Service

Hybrid Amplifier Alarm Data Parameters

Parameter ICIM
Name (LCI) Abbrev.
Optical InPwr
Input
Power
1
Optical OutPwr
Output
Power
1
Laser 1 LasTemp1
Temperature
1
Laser 2 LasTemp2
Temperature
1
78-4025693-01 Rev D
Description
Enables or disables amplifier
Attenuates optical output by value
selected
Module redundancy control:
If set to Master, unit only

controlled by Enable controls
If set to Slave, unit only

controlled by external alarm
signal
Disables low input power alarms
and shuts amplifier down when
optical input level falls below -10.0
dBm
Sets optical output level to 15.0
dBm for servicing
Nominal Major
Value Low
Limit
- -16
dBm
- -1.0
dBm
25.0°C -20.0°C
25.0°C -35.0°C
Values
ON (1)
OFF (0)
0 to 3 dB
in 0.5 dB steps
Master (1)
Slave (0)
ON (1)
OFF (0)
ON (1)
OFF (0)
Minor Minor Major
Low High High
Limit Limit Limit
-5.0 25 45
dBm dBm dBm
-0.7 -0.7 1.0
dBm dBm dBm
-15.0°C 15.0°C 20.0°C
-30.0°C 45.0°C 50.0°C
Hybrid Amplifier Parameters
Default
OFF (0)
0 dB
Master
(1)
OFF (0)
OFF (0)
Hys- Operating
teresis Range
1.0 -
0.1 -
1.0 OK or
Alarm
1.0 OK or
Alarm
145