Show Command - Cisco Prisma II Hybrid Amplifier Installation Manual

Chapter 3 Operation Using CLI
Value
TOS
TZONE
UPDATEID
Any number of these values can be listed, and the output returns the values in the
order requested.
The sample dialog below shows how this command might be sent by a network
management system.
CLI> icim info IP devtype serial swrev attnstatus size exit
IP
172.23.200.154 5011
SUCCESS!
CLI>

Show Command

The show command is used to request information about the ICIM settings in the
info command and about the elements in the ICIM domain, how they are currently
provisioned (configured), and what traps are defined in the Traps table. The basic
command syntax is:
show argument
where argument specifies whether the request is for those items in the info
command, or for domain, provisioning, traps, or clock information, as further
explained below.
Show Domain
This command displays a list of all of the modules in the ICIM domain. The sample
dialog below illustrates the use of this command.
ICIM> show domain <Enter>
MODID
20/03
20/05
20/07
20/08
20/05
SUCCESS!
ICIM>
In the response, each module is identified by its chassis and slot number (MODID)
as well as by object type (DEVTYPE), serial number (SERIAL), software revision
number (ACTIVEREV), and product description (NAME).
50
Function
Time of Service of the ICIM
Time zone string setting
Always zero (0); this is a write-only value
DEVTYPE SERIAL
AADORTI
DEVTYPE SERIAL ACTIVEREV
5010 1234567 1.00.05
1031 12345678 1.65.00
3030 AACZOIF 1.00.05
3031 !AAGJUHB 1.00.05
3019 AAG1AZI 1.01.02
SWREV ATTNSTATUS
0.00.15 0
CODEREV NAME
CF_CCB3 Power Supply 3 /
CF_CCB3 1550nm EM TX FTTP
CF_CCB3 1550nm Pre-Amp FTTP
CF_CCB3 1550nm Post-Amp FTTP
CF_CCB Prisma II Hybrid Amp
SIZE
8
Fan Tray
78-4025693-01 Rev D