78-4025693-01 Rev D
3
Chapter 3
Operation Using CLI
Introduction
This chapter describes the procedures for using the CLI to monitor the
module. The procedures used in this chapter apply if you are using
the Prisma II ICIM2 to monitor the module.
For an overview of module operating features, see Module
Introduction (on page 1).
Laser Warning
WARNING:
Avoid damage to your eyes! Do not look into any optical connector
while the system is active. Even if the unit is off, there may still be
hazardous optical levels present.
In This Chapter
Using the CLI ......................................................................................... 31
Module Commands .............................................................................. 38
ICIM Commands .................................................................................. 48
Terminal Commands ............................................................................ 56
29