To View Active User Alarms; To Set Adjustable Alarm Thresholds Using The Icim - Cisco Prisma II Hybrid Amplifier Installation Manual

To View Active User Alarms

User alarms are alarms for which the user can change threshold values.
When a module ALARMS menu is selected, press the
scroll through alarms. Typical user ALARMS menus are shown below.

To Set Adjustable Alarm Thresholds using the ICIM

You can use the ICIM to change the adjustable alarm thresholds of this module from
their factory default values.
1 At the MODULE menu, press the
ICIM LCD.
2 Press the
label n/a is displayed, you cannot configure that alarm threshold. Press the
key to highlight the alarm threshold for the next parameter.
3 When the threshold that you wish to set is highlighted, press the
4 Press the
Press the
5
Note: Press the Cancel (
6 Press the
ICIM LCD.
7 When finished, press the
78-4025693-01 Rev D
key. The alarm thresholds previously set are displayed. If the
key or the key to change the increment size.
key or the key to adjust the alarm threshold.
) key to return to the previous menu.
key to save the changes. The message Data Saved appears on the
key to return to the MAIN menu.
Checking Alarms using the ICIM
key or the
key. The STATUS menu appears on the
key to
key.
85