Reboot Command; Traps Command - Cisco Prisma II Hybrid Amplifier Installation Manual

IPRoute Show
This command can be used to list all current entries in the listing of alternate
gateways for routing TCP/IP packets.

Reboot Command

The reboot command causes the ICIM to be reset. The basic syntax is as follows:
reboot
Note: User of this command requires Admin user permissions.

Traps Command

The traps command allows the entries in the Trap table to be enabled or disabled,
and allows the IP address of the Trap table to be set. The basic syntax is as follows:
traps trapenable trapindex [IPAddress]
where
trapenable is enable or disable to specify the command function.
trapindex is the table index (0-4).
[IPAddress] is the optional IP address to put in the table.
Note:
Admin permissions are required to use this command.

The Trap table has 5 entries, indexed 0-4. Each entry can be enabled by supplying

a valid IP address, or if the table entry already has a valid IP address.
When disabling an entry in the Traps table, you can specify an empty IP address,

i.e., 0.0.0.0.
See the Show Traps section of Show Command (on page 50) for instructions on
viewing selected portions of the Trap table.
78-4025693-01 Rev D
ICIM Commands
55