User Command - Cisco Prisma II Hybrid Amplifier Installation Manual

Set Clock
This command allows the ICIM real time clock (RTC) to be set and confirmed by a
single command, as shown in the following example.
ICIM> set clock 10/5/2005 12:40:00
MM-DD-YYYY
10-05-2005
SUCCESS!
ICIM>

User Command

The user command permits control and monitoring of system users and their
authorization levels. The basic syntax is as follows:
user argument value
where argument specifies whether the command is to add, change, delete, or show
user information, as further explained below.
User Add
This command can be used by the Admin user to add a new login and password to
the authentication table. A dialog is used to obtain the and validate the password.
The new authorization level s given on the command line, and can be one of the
following.
Authorization
ADMIN
READWRITE
READ
User Change
This command can be used by the Admin user to change the password of an existing
user. A dialog is used to obtain and validate the new password. The basic syntax is
as follows:
user change (username)
user add (username) (authorization level)
78-4025693-01 Rev D
HH:mm:ss
12:40:00
Description
Equivalent to a Unix superuser (root) and should be allowed for
only the most trusted logins. An Admin can change passwords, IP
addresses, and other critical values.
Allows typical operations, including the ability to change control
values and alarm parameters.
Allows the user to read non-critical values only, and has no write
permissions.
ICIM Commands
53