Create A Cluster - IBM System Storage DS3500 Introduction And Implementation Manual

Draft Document for Review March 28, 2011 12:24 pm
Figure 19-16 Failover Cluster Validation Report

19.4.3 Create a Cluster

After a successful validation of the cluster configuration, we can start with cluster installation.
Follow the steps below:
1. Confirm that Failover Cluster Management is selected and then, in the center pane
under Management, click Create a cluster as shown in Figure 19-17 on page 588 and
click Next.
Microsoft Cluster configuration with DS3500.fm
Chapter 19. Microsoft Cluster configuration with DS3500
587