IBM System Storage DS3500 Introduction And Implementation Manual page 180

7914InstallSM01108.fm
Note:
When you add new storage subsystems to the existing storage subsystems in a SAN
that are managed through the host-agent software, you must stop and restart the
host-agent service. When the host-agent service restarts, the new storage subsystem
is detected. Then, go to the Enterprise Management Window and click Tools 
Rescan to add the new storage subsystems to the management domain.
When you add new storage subsystems to existing storage subsystems that are
managed using the direct-management method, be sure to specify the IP addresses for
both controllers.
To add the Storage Subsystem manually:
1. From the Setup tab DS Storage Manager Enterprise Management window, click on Add
Storage Subsystem link as shown in Figure 5-22 on page 154
Figure 5-25 Add Storage Subsystem
2. Select the Manual button as shown in Figure 5-26 and click OK.
Figure 5-26 Select Addition Method-Manual
156
IBM System Storage DS3500: Introduction and Implementation Guide
Draft Document for Review March 28, 2011 12:24 pm