Recovery - Place Controller; Place Controller Online - IBM System Storage DS3500 Introduction And Implementation Manual

7914support2-0209.fm
Figure 14-131 Clear Array Configuration
3. Type "yes" in the textbox and click OK to clear the array configuration.

14.14.4 Recovery - Place controller

You can use the Advanced  Recovery  Place controller submenu functions to set the
selected controller state to online, offline or service mode. In this section we describe how to
use these options.
Note: These three functions should normally only be used under the guidance of your IBM
technical support representative.

Place controller Online

Placing a controller online sets it to Optimal status and places it in an active mode, available
for I/O operations. Under normal operating conditions, both controllers will be online and in
the optimal state. This function is only used if one of the two controllers is in either the offline
state, or in service mode.
Do the following to use this option:
1. Select the controller in the Physical tab of the DS Storage Manager (Subsystem
Management) window and then select the Advanced  Recovery  Place controller 
Online menu command, as shown in Figure 14-132 on page 429.
428
IBM System Storage DS3500: Introduction and Implementation Guide
Draft Document for Review March 28, 2011 12:24 pm