IBM System Storage DS3500 Introduction And Implementation Manual page 563

Draft Document for Review March 28, 2011 12:24 pm
SMcli -a email:<email address>
host_sa)]}
SMcli {-a | -x} trap:<community>,<hostname or IP address>
host_sa)}
SMcli -?
For additional information, refer to your Command Line Interface documentation
SMcli completed successfully.
amazon:~ #
The various syntax options shown by SMcli -? perform the following tasks:
Execute commands on a given storage subsystem that are specified on the command line
over an out-of-band management connection.
Execute commands that are specified in a command script over an out-of-band
management connection.
Execute commands on a given storage subsystem that are specified on the command line
over an in-band management connection.
Execute commands that are specified in a command script over an in-band management
connection.
List defined storage subsystems.
Add storage subsystems to the configuration file of the Enterprise Management Window.
Remove an already defined e-mail alert.
Configure e-mail alerts.
Configure or remove SNMP alerts.
As we said, the CLI can perform all the functions provided by the Storage Manager GUI. In
the GUI, the first four tasks are performed in the subsystem management windows of a
specific subsystem and the last five tasks ("List defined storage subsystems" and onwards)
can be performed in the Enterprise Management Windows of the client
Note: Always specify the IP addresses or host names from the management interface of
all installed DS3500 controllers.
Table 17-2 on page 540 gives an explanation of the various parameters that can be specified
with SMcli commands.
[-S]
[<hostname or IP address1> [<hostname or IP address2>]]
[-n <storage-array-name> | -w <WWID> | -h <hostName> | -r (direct_sa |
[-I <informationToInclude>] [-q <frequency>] [-S]
[<hostname or IP address1> [<hostname or IP address2>]]
[-n <storage-array-name> | -w <WWID> | -h <hostName> | -r (direct_sa |
[-S]
7914appCLI1208.fm
Chapter 17. Command-Line Interface(CLI)
539