Create Cluster Command; Query Status Command - IBM Storwize V7000 Troubleshooting And Maintenance Manual

Create cluster command

Use this command to create a storage system.
Syntax
satask mkcluster -clusterip
satask mkcluster -clusterip_6
Parameters
-clusterip
(Optional) The IPv4 address for Ethernet port 1 on the system.
-gw
(Optional) The IPv4 gateway for Ethernet port 1 on the system.
-mask
(Optional) The IPv4 subnet for Ethernet port 1 on the system.
-clusterip_6
(Optional) The IPv6 address for Ethernet port 1 on the system.
-gw_6
(Optional) The IPv6 gateway for Ethernet port 1 on the system.
-prefix_6
(Optional) The IPv6 prefix for Ethernet port 1 on the system.
-name
(Optional) The name of the new system.
Description
This command creates a storage system.
This command calls the satask mkcluster command.

Query status command

Use this command to determine the current service state of the node canister.
Syntax
sainfo getstatus
Parameters
None.
Description
This command writes the output from each node canister to the USB flash drive.
This command calls the sainfo lsservicenodes command, the sainfo
lsservicestatus command, and the sainfo lsservicerecommendation command.
ipv4
-gw ipv4 -mask
ipv6
-gw_6 ipv6 -prefix_6
Chapter 5. Storwize V7000 user interfaces for servicing your system
ipv4 -name cluster_name
int -name cluster_name
41