Table of Contents
Advertisement
Risk of explosion if battery is replaced by an incorrect type. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Dispose of used battery according to the instructions.
Disconnect the power cord from all power sources to completely remove power from the device.
Make sure to choose the appropriate circuit device depending on the number of AC power supplies
installed in the device. The minimum current draw for the system is one AC power supply.
Power supplies are hot swappable. However, Brocade recommends that you disconnect the power supply
from AC power before installing or removing the supply. The device can be running while a power supply is
being installed or removed, but the power supply itself should not be connected to a power source.
Otherwise, you could be injured or the power supply or other parts of the device could be damaged.
Make sure that the power source circuits are properly grounded, then use the power cord supplied with
the device to connect it to the power source.
If the installation requires a different power cord than the one supplied with the device, make sure you
use a power cord displaying the mark of the safety agency that defines the regulations for power cords in
your country. The mark is your assurance that the power cord can be used safely with the device.
For safety reasons, the ESD wrist strap should contain a series 1 MB ohm resistor.
Preparing the installation site
Cabling infrastructure
Ensure that the proper cabling is installed in the site. Refer to <Link>"Device specifications" on page 50 or visit
for a summary of supported cabling types and their specifications.
Brocade TurboIron 24X Series Hardware Installation Guide
Part Number: 53-1003053-03
Installing the TurboIron 24X
Preparing the installation site
http://www.brocade.com
23
Advertisement
Table of Contents
