Debug Ip Verify Source Packet - Cisco catalyst 3750 Command Reference Manual

debug ip verify source packet

debug ip verify source packet
Use the debug ip verify source packet privileged EXEC command to enable debugging of IP source
guard. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(20)SE
Usage Guidelines The undebug ip verify source packet command is the same as the no debug ip verify source packet
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Catalyst 3750 Switch Command Reference
B-18
debug ip verify source packet
no debug ip verify source packet
Modification
This command was introduced.
Appendix B
Description
Displays information about the types of debugging that are
enabled.
Catalyst 3750 Switch Debug Commands
OL-8552-07