Hyundai N700E Instruction Manual page 85

N700E INSTRUCTION MANUAL
Local Keypad Operation [O/R], Local Terminal Input Operation [T/R]
• In case of operation by other than using keypad or terminal, it can be changed to local keypad operation
(O/R function (20)) or local terminal input (T/R function (21)) by the multi-function input for the purpose of
conducting manual operation method change.
• Assign 20 (O/R) or 21(T/R) to the intelligent input terminals 1~6 for the Local by-pass operation
• Acceleration time operates according to F02, F03 whether the local keypad or terminal input operation
command is "on" or "off".
Option Terminal
Code Symbol
20 O/R
21 T/R
Valid for inputs:
Required setting
Notes:
• When the C01 ~ C06 terminal input has both the O/R(20) and T/R(21) input definition, and both of the
terminal input is "ON" status, O/R(20) operation has the initiative action in the operation command. In this
case the terminal input of definition T/R(21) is ignored.
• When the inverter is running status and the O/R or T/R terminal input status is changed from "on" to "off"
or "off" to "on", the inverter will be stopped whether the O/R and T/R command input is given or not. After the
motor is stopped and the inverter run command must be given to the inverter for the "running" operation
After the by-pass operation command is given or cancelled and the motor will restart suddenly if the Run
command is already active.
Be sure to set or reset the by-pass operation command after verifying that the Run command is off to
prevent injury to personnel.
Input
Function Name
State
ON
Local Keypad
Operation
OFF
ON
Local Terminal
Input Operation
OFF
C01,C02,C03,C04,C05,C06
(none)
Frequency command is changed to the keypad
potentiometer (like as A01 = 0) and Run command is
changed to Standard Operator (like as A02 = 0).
Frequency command is changed to the A01 setting
method and Run command is changed to A02 setting
method.
Frequency command is changed to the control terminal
input (like as A01 = 1) and Run command is changed to
the control terminal input (like as A02 = 1).
Frequency command is changed to the A01 setting
method and Run command is changed to A02 setting
method.
DANGER
5-18
Description