Hyundai N700E Instruction Manual page 3

N700E INSTRUCTION MANUAL
SAFETY
FOR THE BEST RESULTS WITH N700E SERIES INVERTER, READ THIS MANUAL AND ALL OF THE
WARNING SIGN ATTACHED TO THE INVERTER CAREFULLY BEFORE INSTALLING AND OPERATING IT,
AND FOLLOW THE INSTRUCTION EXACTLY. KEEP THIS MANUAL HANDY FOR YOUR QUICK
REFERENCE.
DEFINITIONS AND SYMBOLS
A SAFETY INSTRUCTION (MESSAGE) IS GIVEN WITH A HAZARD ALERT SYMBOL AND A SIGNED
WORD, WARNING or CAUTION.
EACH SIGNAL WORD HAS THE FOLLOWING MEANING THROUGHOUT THIS MANUAL.
THIS SYMBOL MEANS HAZARDOUS HIGH VOLTAGE. IT USED TO CALL YOUR
ATTENTION TO ITEMS OR OPERATIONS THAT COULD BE DANGEROUS TO YOU OR
OTHER PERSONS OPERATING THIS EQUIPMENT.
READ THESE MESSAGES AND FOLLOW THESE INSTRUCTIONS CAREFULLY.
THIS IS THE "SAFETY ALERT SYMBOL". THIS SYMBOL IS USED TO CALL YOUR
A TTENTION TO ITEMS OR OPERATIONS THAT COULD BE DANGEROUS TO YOU OR
OTHER PERSONS OPERATING THIS EQUIPMENT.
READ THESE MESSAGES AND FOLLOW THESE INSTRUCTIONS CAREFULLY.
WARNING INDICATES A POTENTIALLY HAZARDOUS SITUATION WHICH,
IF NOT AVOIDED, CAN RESULT IN SERIOUS INJURY OR DEATH.
CAUTION INDICATES A POTENTIALLY HAZARDOUS SITUATION WHICH, IF NOT AVOIDED,
CAN RESULT IN MINOR TO MODERATE INJURY, OR SERIOUS DAMAGE OF PRODUCT.
THE MATTERS DESCRIBED UNDER
LEAD TO SERIOUS RESULTS DEPENDING ON THE SITUATION. IMPORTANT MATTERS
ARE DESCRIBED IN CAUTION (AS WELL AS WARNING), SO BE SURE TO OBSERVE THEM.
NOTE NOTES INDICATE AN AREA OR SUBJECT OF SPECIAL MERIT,
HAZARDOUS HIGH VOLTAGE
MOTOR CONTROL EQUIPMENT AND ELECTRONIC CONTROLLERS ARE CONNECTED
TO HAZARDOUS LINE VOLTAGE.
WHEN SERVICING DRIVES AND ELECTRONIC CONTROLLERS,
THERE MIGHT BE EXPOSED COMPONENTS WITH CASES OR PROTRUSIONS AT OR
ABOVE LINE POTENTIAL.
EXTREME CARE SHOULD BE TAKEN TO PRODUCT AGAINST SHOCK. STAND ON AN
INSULATING PAD AND MAKE IT A HABIT TO USE ONLY ONE HAND WHEN CHECKING
COMPONENTS.
ALWAYS WORK WITH ANOTHER PERSON IN CASE AN EMERGENCY OCCURS.
DISCONNECT POWER BEFORE CHECKING CONTROLLER OR PERFORMING
MAINTENANCE.
BE SURE EQUIPMENT IS PROPERLY GROUNDED. WEAR SAFETY GLASSES
WHENEVER WORKING ON AN ELECTRIC
CONTROLLER OR ROTATING ELECTRICAL EQUIPMENT.
EMPHASIZING EITHER THE PRODUCT`S CAPABILITIES OR COMMON
ERRORS IN OPERATION OR MAINTENANCE.
CAUTION MAY, IF NOT AVOIDED,
II