Drip Shield Installation (For Marine Installations); Figure 1-10 Drip Shields - Xantrex Freedom HF 1000 Installation Manual

FreedomHF_IC_01-Installation.fm Page 31 Monday, December 24, 2007 9:47 AM

Drip Shield Installation (For Marine Installations)

975-0395-01-01
The drip shield helps to protect the unit from dripping or splashing
liquids, which will cause a shock hazard. Drip shields are especially
useful in marine installations where water from condensation, rain, or sea
may come into contact with the
WARNING: Shock hazard
This product is intended only for use in dry areas. Operating the unit under wet
conditions may expose you to a shock hazard. Installing drip shields may not
entirely protect you from this hazard. Do not operate the unit when it is wet.
You may purchase the drip shield set by contacting Xantrex. When
ordering, mention part number 808-9531.

Figure 1-10 Drip Shields

To install the drip shields:
1. Gather the four screws needed to fasten a single drip shield to a wall.
2. Locate an appropriate setting for the drip shields above the
HF making sure you cover the entire width of the unit.
You can overlay the shields as shown in
This guide for use by qualified installers only
Drip Shield Installation (For Marine Installations)
Freedom HF.
Different Views)
Drip Shield set part# 808-9531
Figure 1-11
Freedom
below.
1–31