Xantrex Freedom HF 1000 Installation Manual page 36

FreedomHF_IC_01-Installation.fm Page 18 Monday, December 24, 2007 9:47 AM
13. Insert the Line and Neutral wires into the corresponding terminals.
14. Tighten the wire attachment screws to a torque of 1.3–1.8 lbf-ft
15. Secure the AC cable by adjusting the strain-relief clamps.
If you do not plan to proceed with
an Existing AC Circuit" on page
16. Install the GFCI back into the front panel of the unit.
1–18
(1.76–2.44 Nm). Leave some wiring slack inside the wiring
compartment.
Alternatively, if you do not reinstall the GFCI, make sure that you cap
the exposed wires and install a blanking plate to cover the space
vacated by the GFCI.
This guide for use by qualified installers only
"Step 5: Connecting AC Output to
1–19, follow the succeeding substep.
975-0395-01-01