Testing In Shore Power Mode - Xantrex Freedom HF 1000 Installation Manual

FreedomHF_IC_01-Installation.fm Page 30 Monday, December 24, 2007 9:47 AM

Testing in Shore Power Mode

To test the
◆ With the appliance from the previous test still connected and
Note:
will automatically supply the appliances with inverter power if the shore power
source fails or becomes disconnected.
If the Inverter button on the
too low (less than 90 volts AC), the unit will transfer to inverter power to continue
running your appliances.
WARNING: Shock hazard
Whether or not the Inverter button is turned ON, shore power will pass through
the
range.
1–30
Freedom HF in shore power mode:
operating, connect the shore power source.
The Freedom HF transfers the appliances to shore power. The status
LED on the display panel will change from yellow to a ten-second
flashing yellow and then green.
If the appliance operates, your installation is successful.
If the Inverter button on the
Freedom HF
Freedom HF to the output when shore power is within normal operating
This guide for use by qualified installers only
Freedom HF is turned ON, the
is turned ON and shore power voltage is
Freedom HF
975-0395-01-01