Table of Contents
Advertisement
Marine Installation
Drip Shield Installation
The drip shields help to protect the unit from dripping or splashing liquids, which will cause a shock hazard when moisture comes in
contact with electrical circuits in the unit. The drip shields are especially useful in marine installations where water from
condensation, rain, or sea may come into contact with the Freedom EX 4000.
ELECTRICAL SHOCK HAZARD
Place this unit in normally dry areas only. Operating the unit under wet conditions may expose you to a shock hazard. Installing drip
shields may not entirely protect you from this hazard. Do not operate the unit when it is wet.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
You may purchase the Drip shield set by contacting customer support. When ordering, mention part number 808-9004.
Figure 33 Drip shields over deck mounted units
Figure 34 Drip shields over wall mounted units
44
WARNING
To install the drip shields:
1. Gather the ten #6 pan-head steel screws needed to fasten a single drip
shield to a wall.
2. Locate an appropriate setting for the drip shields above the Freedom EX
4000 making sure you cover the entire width of the unit and not the length
as shown in Figure 33 . On wall mounted unit, make sure the width of the
unit is covered as shown in Figure 34 .
3. Fasten the screws through the holes in the drip shield into the wall. See
Figure 33 .
Freedom EX 4000 Installation Guide
Advertisement
Table of Contents
