Table of Contents
Advertisement
FreedomHF_IC_01-Installation.fm Page 13 Monday, December 24, 2007 9:47 AM
Step 3: Mounting the
975-0395-01-01
Freedom HF
To mount the
Freedom
HF:
1. Remove the
Freedom HF
components are present, and record relevant product information on
"Information About Your System" on page
2. Select an appropriate mounting location and orientation. (See
1-3
below.) To meet regulatory requirements, for use in on-land
applications, the
Freedom HF
following orientations:
•
Under a horizontal surface (see 1)
•
In a horizontal position on a vertical surface (see 2)
Note:
For marine installations, only this orientation is allowed,
due to the probability of moisture finding access into the
enclosure.
•
On a horizontal surface (see 3)
1
2
3
Figure 1-3 Approved Mounting Orientations
3. Look for the mounting template and unfold. Tape it to the mounting
surface and pilot-drill the desired number of mounting holes. Remove
the template.
4. Fasten the
Freedom HF
the unit on a wall or bulkhead, use #12 or #14 pan-head wood or sheet
metal screws to secure it to the framing behind the wall or bulkhead.
Alternatively, use nut inserts and 1/4-20 machine screws.
This guide for use by qualified installers only
Basic Installation Procedures
from its shipping container, verify that all
WA–4.
must be mounted in one of the
See
shield installation on
Marine applications.
to the mounting surface. If you are mounting
Figure
page 1–31
for drip
1–13
Hide quick links:
Advertisement
Table of Contents
