Freedom HF Install Guide.book Page 2 Friday, December 21, 2007 9:57 PM
Marine Installation
Figure B-1
components:
1. AC power supplied from a shore power connector
2. An AC source panel that includes a Max 30A circuit breaker that
3. An AC load panel with branch circuit breakers that supply only loads
4. Engine negative bus / DC ground bus
5. DC power supplied by a battery bank and protected by a DC fuse in
6. Battery isolator
7. DC alternator
8. Starting battery
9. Drip shield (not shown)
B–2
illustrates a typical marine installation with the following
supplies the
Freedom HF
that run off the
Freedom HF
the positive cable
This guide for use by qualified installers only
975-0395-01-01