Xantrex Freedom HF 1000 Installation Manual page 44

FreedomHF_IC_01-Installation.fm Page 26 Monday, December 24, 2007 9:47 AM
9. To prevent sparking when making the connection, ensure the
10. Attach the connector on the positive cable to the positive DC terminal
11. Install the lock washer and nut that are supplied with the inverter.
CAUTION
Loose connections cause excessive voltage drop and may cause overheated wires
and melted insulation.
CAUTION
Do not over-tighten the nut on the DC input terminals. Damage to the DC input
terminals may result.
The maximum torque setting is 120 in-lbf (13.6 N-m).
CAUTION: Reverse polarity
DC power connections to the
negative to negative.
A reverse polarity connection (positive to negative) will blow a fuse in the
inverter and may permanently damage the inverter. The fuse is not user
replaceable and the inverter may need to be returned for servicing.
Damage caused by a reverse polarity connection is not covered by your warranty.
12. Before proceeding, double check that the cable you have just installed
.
WARNING: Explosion or fire
Do not complete the next step if flammable fumes are present. Explosion or fire
may result if the disconnect/battery selector switch is not in the off position.
Thoroughly ventilate the battery compartment before making this connection.
13. Connect the cable from the negative post of the battery to the negative
1–26
disconnect/battery selector switch is off.
on the inverter.
Tighten the nut to a torque of 108–120 in-lbf (12.2–13.6 N-m). Make
the connection snug enough so the ring terminal does not move
around on the DC terminal, but do not overtighten. See
"DC Cable Connections" on page
Freedom HF
connects the positive DC terminal of the inverter to the disconnect/
battery selector switch, fuse holder, and that the other end of the fuse
holder is connected to the positive terminal of the battery.
DC terminal of the inverter.
This guide for use by qualified installers only
Figure 1-9,
1–27.
must be positive to positive and
975-0395-01-01