FreedomHF_IC_02-Configuration.fm Page 4 Monday, December 24, 2007 9:48 AM
To adjust the alarm setting:
By default the alarm is set to ON.
•
Whenever the alarm setting is changed, the display will temporarily show
either "AL0" or "AL1" and after a few seconds will return to displaying
what was on the screen prior to the adjustment.
To adjust the charging current:
By default the charging current is set to:
1. Press and hold the Inverter button for five seconds.
2. Press the Select button to toggle between the different Amp ratings.
3. Choose the desired charging current by stopping at the value shown
2–4
Press and hold the Select button for two seconds.
The display shows "AL0" indicating that the alarm is OFF.
The display shows "AL1" indicating that the alarm is ON.
Note:
The alarm setting will reset to its default setting when the
Freedom
HF's Inverter button is turned OFF then turned ON
again.
•
20A for the
Freedom HF 1000
•
40A for the
Freedom HF 1800
The unit will go into Charge Current Setting Mode.
2 — 5 — 10 — 20 for the
•
2 —10 — 20 — 40 for the
•
on the display. To maximize unit performance, see
"Charging Current Guidelines"
Wait for five seconds and the charging current is set.
This guide for use by qualified installers only
Freedom HF 1000
Freedom HF 1800
Table 2-1
below.
975-0395-01-01