Marine Installation - Xantrex Freedom Xi 807-1000 Installation Manual

Marine Installation

Figure 9 illustrates a typical marine installation with the following
components:
1. AC power supplied from a shore power connector
2. An AC source panel that includes a Max 30A circuit breaker
that supplies the Freedom Xi
3. An AC load panel with branch circuit breakers that supply only
loads that run off the Freedom Xi
4. Engine negative bus / DC ground bus
5. DC power supplied by a battery bank and protected by a DC
fuse in the positive cable
6. Battery isolator
7. DC alternator
8. Starting battery
9. Drip shield (see next page)
975-0753-01-01
DC Fuse /
disconnect or
circuit breaker
12V Deep Cycle
Battery
Starting Battery
Figure 9 Typical Marine Installation
AC Load Panel
AC Source Panel
Shorepower
29