To Power On Using The On/Standby Switch; To Power Off The System Using The On/Standby Switch - Sun Microsystems Sun Fire V210 Installation Manual

5. At the console sc> prompt, type the following command to power on the server:
sc> poweron

To Power On Using the On/Standby Switch

Caution – Never move the system when the system power is on. Movement can
cause catastrophic disk drive failure. Always power off the system before moving it.
1. Connect the server to the power supply.
The server automatically goes into Standby power mode when it is connected to a
power source.
2. Turn on power to any peripherals and external storage devices you have connected
to the server.
Read the documentation supplied with the device for specific instructions.
3. Open the front bezel.
4. Sun Fire V240 only: insert the system key into the keyswitch and set it to the
Normal or Diagnostics position.
5. Press the On/Standby switch.
6. Sun Fire V240 only:
a. Turn the key switch to the Locked position.
This prevents anyone from accidentally powering off the system.
b. Remove the system key from the keyswitch and store it in a secure place.
7. Close the front bezel.
To Power Off The System Using The
On/Standby Switch
Note – Applications running on the Solaris operating environment can be adversely
affected by a poorly executed system shutdown. Make sure you have gracefully shut
down any applications before powering off the system.
Chapter 4 Powering On and Configuring the Server 43