Clearing Your Configuration; To Clear The Configuration And Start Again; Accessing Advanced Lights-Out Manager (Alom) - Sun Microsystems Sun Fire V210 Installation Manual

Clearing Your Configuration

If you want to start the power on process again, as if from a previously unused
server, you must clear the configuration of the server.

To Clear the Configuration and Start Again

1. At the Solaris prompt, type:
# sys-unconfig
2. When prompted to confirm that you want to create a "blank" server, type y.
3. When the OBP prompt appears, type:
ok> boot
4. Follow the instructions in one of the following sections:
"To Configure With the Server's Details Registered at a Name Server" on page 45
or
"To Configure Without the Server's Details Registered at a Name Server" on
page 45
"To Configure a Standalone Server for the First Time" on page 46
Accessing Advanced Lights-Out
Manager (ALOM)
For a brief introduction, see "Sun Advanced Lights-Out Manager" on page 4. For
detailed ALOM instructions, and configuration information, refer to the ALOM
Online Help which is included on the Sun Fire V210 and V240 Server Documentation
CD.
The ALOM software is preinstalled on the server and is ready to run as soon as
power is applied to the server. However, you need to perform some basic
configuration steps to customize the ALOM software to suit your application.
Chapter 4 Powering On and Configuring the Server 47