Figure 2-8 Using The Spacer Tool At The Back Of The Rack; Figure 2-9 Slide Assembly Parallel Alignment - Sun Microsystems Sun Fire V210 Installation Manual

10. At the back of the rack, insert the narrow cutouts in the spacer tool into the slots
in the slide assemblies.
See for slot location.
FIGURE 2-8
Use this cutout to align the
backs of the slide assemblies
Using the Spacer Tool at the Back of the Rack
FIGURE 2-8
11. Fully extend the spacer tool.
This ensures that the slide assemblies are parallel. See
Front of rack
Slide Assembly Parallel Alignment
FIGURE 2-9
.
FIGURE 2-9
Back of rack
Chapter 2 Installing the Hardware 17