Using The Power (On/Standby) Switch; Figure 7-1 Model 100 System Switch; Figure 7-2 Model 105 System Switch - Sun Microsystems Netra t1 100 User And Administration Manual

Using the Power (On/Standby) Switch

Caution – The power switch (on the rear panel of the Netra t1 system) is not an
On/Off switch, it is an On/Standby switch. It does not isolate the equipment.
The power (On/Standby) switch of the Netra t1 system is a rocker, momentary
switch. It controls only low voltage signals; no high-voltage circuits pass through it.
This means that the main method of connecting or disconnecting power is by
inserting or removing the power supply cord(s). The system contains no integral
circuit breakers. To isolate it, you must break all connections to it. If you do not do
this by removing the power supply cord(s), you must instead open all external
circuit breakers.
DC power inlets
Power (On/Standby) switch
Model 100 System Switch
FIGURE 7-1
AC power inlet
Power (On/Standby) switch
Model 105 System Switch
FIGURE 7-2
The symbols on the switch are as follows:
On – Press this to apply power to the system.
Standby – Press this to put the system into Standby mode.
Chapter 7 Powering Up the Netra t1 63