12. Ensure that the brackets on the back of the slide assemblies are mounted centrally
in the rack and are vertical.
FIGURE 2-10
13. With the spacer tool in place, fully tighten the screws at the back of the rack.
14. Remove the spacer tool.
15. At the front of the rack, ensure that the slide assemblies are not extended.
Lift the release catch to close the slide assemblies. You can use the spacer tool to lift
the catches. For latch location, see
18
Sun Fire V210 and V240 Servers Installation Guide • April 2003
Using Spacer Tool at the Back of the Rack
Brackets must be
vertical
.
FIGURE 2-11