Using The Sun Fire V210 And V240 Server With A Terminal Server - Sun Microsystems Sun Fire V210 Installation Manual

c. Click OK.
The sc> prompt appears in the Windows Hyperterminal.
Using the Sun Fire V210 and V240 Server
With a Terminal Server
The serial ports on the Sun Fire V210 and V240 server are DTE ports. If you connect
these to other DTE ports, then the cabling between them must perform a crossover
(also known as a roll-over).
If the pinouts for the server's serial ports correspond with the pinouts for the RJ-45
ports on the terminal server, you have two connection options:
Connect a serial interface breakout cable directly to the Sun Fire V210 and V240
server.
Connect a serial interface breakout cable to a patch panel and use the straight-
through patch cable (supplied by Sun) to connect the patch panel to the server.
Terminal
server
Patch panel
Sun Fire V240
Patch Panel Connection Between a Terminal Server And A Sun Fire V240
FIGURE 3-1
1 2 3 4
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Chapter 3 Communicating With The Server
5 6 7 8 9 10 11 12 13 14 15
Straight-through cable
Patch cable
39