To Display The Alom Prompt; To Display The Console Prompt - Sun Microsystems Sun Fire V210 Installation Manual

To Display The ALOM Prompt

1. Type the default keystroke sequence:
# #.
Note – When you switch to the ALOM prompt after initial poweron, you will be
logged in as the admin user and prompted to set a password. You must set this
password in order to execute certain commands.
If you are prompted to do so, set a password for the admin user.
The password must:
contain at least two alphabetic characters
contain at least one numeric or one special character
be at least six characters long
Once the password is set, the admin user has full permissions and can execute all
ALOM CLI commands.

To Display the Console Prompt

1. Type:
sc> console
More than one ALOM user can be connected to the server console stream at a time,
but only one user is permitted to type input characters to the console.
If another user is logged on and has write capability, you will see the message below
after issuing the console command:
sc> Console session already in use. [view mode]
48 Sun Fire V210 and V240 Servers Installation Guide • April 2003