Cabletron Systems SmartSwitch 8000 Getting Started Manual page 105

configuring the SSR for TACACS and RADIUS can be found in the SmartSwitch Router
User Reference Manual.
Note: If a password is configured for Enable mode, the SSR prompts for the password
when you enter the enable command. Otherwise, the SSR displays a message
advising you to configure an Enable password, then enters Enable mode. From
Enable mode, you can access Configure mode to make configuration changes.
The default password for each access level is blank. (Simply press Enter or Return without
entering a password.) If you want to add password protection to the CLI, use the
following procedure.
1. Ensure that you are in Enable mode by entering the enable command in the CLI.
2. Ensure that you are in Configure mode by entering the configure command in the
CLI.
3. Type the following command for each password you want to set:
system set password login|enable <string>|none
4. Use the show command to examine the commands you just entered.
5. Use the save active command to activate the commands.
6. Use the system show active-config command to verify the active changes.
Here is an example of the commands in the previous steps:
ssr(config)# system set password login demo
ssr(config)# system set password enable demo
ssr(config)# save active
ssr# exit
ssr# system show active-config
Running system configuration:
!
! Last modified from Console on Mon Jun 14 12:12:19 1999
!
1 : system set name "ssr"
2 : system set location "Houston, TX"
3 : system set contact "John Smith"
4 : system set hashed-password login jNIssH c976b667e681d03ccd5fc527f219351a
5 : system set hashed-password enable zcGzbO 5d1f73d2d478ceaa062a0b5e0168f46a
6 : snmp set community public privilege read
7 : snmp set target 16.50.11.12 community public
SSR 8000/8600 Getting Started Guide
Chapter 3: Software Installation and Setup
91