Cabletron Systems SmartSwitch 8000 Getting Started Manual page 71

The following table lists the environmental specifications for the SSR's AC Power
Supplies
Operating Temperature
Non-operating
temperature
Operating Humidity
Figure 28
following the figure describes how to do this.
SSR-8
AC Power Supply Installation Procedure
To install an AC power supply:
1. Ensure that the AC power supply is not powered on.
2. If a cover plate is installed over the power supply slot, use the #2 Phillips-head
screwdriver to remove it. If you are replacing an AC power supply, unplug the power
cable from the supply you are replacing, loosen the captive screws on the power
supply's front panel, then pull the supply out of the chassis.
SSR 8000/8600 Getting Started Guide
+5° to +40°C (41° to 104°F)
-30° to +73°C (-22° to 164°F)
15% to 90% (non-condensing)
shows an example of how to install an AC power supply. The procedure
PWR
SSR-PS-8
100-125~5A
200-240~3A
50-60 Hz
Figure 28. Installing an AC Power Supply
Chapter 2: Hardware Installation
57