Table of Contents
Advertisement
Note:
Never attempt to rack mount the SSR chassis unaided. Ask an assistant to help
you hold the chassis.
: To make lifting and holding the chassis easier, install the chassis before you install
Caution
line cards or redundant Control Modules and power supplies.
To install the SSR chassis in an equipment rack, use the following procedure. You need a
#2 Phillips-head screwdriver to perform this procedure.
1.
If the front-mounting brackets are already installed on the SSR chassis, go to
If not, do the following:
a.
Align one of the mounting brackets over the corresponding holes in the side of
the chassis. The mounting bracket is correctly positioned when the side with two
open mounting holes is flush with the front of the chassis.
SSR 8000/8600 Getting Started Guide
SSR-16
Figure 27. Installing the SSR 8600 chassis in an equipment rack
Chapter 2: Hardware Installation
Step
2.
55
Advertisement
Table of Contents
Need help?
Do you have a question about the SmartSwitch 8000 and is the answer not in the manual?
Questions and answers