Table Of Contents - Tandberg Data StorageLoader Installation And User Manual

1. About This Guide
1.1. Explanation of Symbols and Notes
1.2. Related Documentation
2. General Information
2.1. Product Description
2.1.1. Front Panel
2.1.2. Rear Panel
3. Installation
3.1. Performing the Installation
3.1.1. Step 1. Unpacking the StorageLoader
3.1.2. Step 2. Installing the StorageLoader in a Rack
3.1.3. Step 3. Connecting Power Cable
3.1.4. Step 4. Removing the Transport Lock
3.1.5. Step 5. Running Power-On Selftest
3.1.6. Step 6. Setting the SCSI ID (SCSI only)
3.1.7. Step 7. Connecting the SCSI Bus Cable (SCSI only)
3.1.8. Step 8. Connecting the SAS cable (SAS only)
3.1.9. Step 9. Connecting the Ethernet Connector
3.1.10. Step 10. Restarting Your System
3.1.11. Step 11. BCR: Labelling of cartridges
3.2. Dismounting the StorageLoader from the rack
4. Operation and Configuration
4.1. System Power-On
4.2. Front Panel Display Modes
4.2.1. Menus
4.2.2. Dialogs
4.2.3. Messages
4.2.4. Status and Information
4.3. Main Menu
4.4. Setup Menu
4.4.1. StorageLoader setup
4.4.2. SCSI/SAS Setup
4.4.3. Remote Management setup
4.5. View Data Menu
4.5.1. StorageLoader Info
4.5.2. Drive Info
4.5.3. Remote Management Info
4.5.4. Statistics
4.6. Utilities Menu
4.6.1. The Maintenance Menus
4.6.2. The Diagnostics Menu
3 StorageLoader Installation and User Manual

Table of Contents

9
10
10
11
12
12
15
17
17
17
18
22
22
23
23
23
24
24
24
25
26
27
27
30
30
32
33
33
34
35
35
35
35
36
36
37
38
38
39
39
39