Edwards STP Series Instruction Manual page 39

STP Series Turbomolecular Pump
CAUTION
3
DO NOT apply surge voltage exceeding 1 kV to the input power line. Always ground the power
cable to prevent electric shock.
Support each cable so as not to apply direct force to the connectors or terminals. Connect each cable
securely with caution, avoiding any obstacles as follows:
1. Connecting the STP connection cable
Connect the socket side of the STP connection cable to the STP connector of the STP pump and
connect the pin side to "P.CONNECTOR X1" of the STP control unit, and connect the plug (pin) side
"MOTOR X4" (equipped SCU-1400, SCU-1500 and SCU-1600) on the STP control unit.
2. Connecting the TMS connection cable (See STP Pump Instruction Manual (B) for use with the
TMS unit only)
Connect the pin side of the TMS connection cable to the "TMS X5" of the STP control unit.
3. Connecting the power (primary side) cable
Connect the power cable to the "AC POWER X2" on the STP control unit rear panel.
March 10 33 Issue 1-b