Ipsec Mobility And Nat; Roaming From Behind Nat To Behind Nat - Nortel 7 Configuration

150 Chapter 8 Configuring IPSec mobility and persistent mode
The Nortel VPN Client status monitor reports if roaming is enabled for the
session. The event log on the Nortel VPN Router reports on IPSec mobility
actions.

IPSec mobility and NAT

If Nortel VPN Client is behind a NAT box with NAT traversal enabled and
encapsulation for ESP protocol is used, UDP encapsulation is preserved after
roaming.

Roaming from behind NAT to behind NAT

In Figure
and NAT box 1 and had an IP1 IP address. After roaming, the client is connected
via access point 2 (AP2) and NAT box 2 and gets an IP address IP2. In this case,
the client IP address and UDP port have been changed after roaming. When a new
IP address has been received by the client, it sends a NAT keep-alive so that the
server can find the ESP UDP port mapping and send the data to the client using
port mapping.
Figure 30 Roaming from behind NAT to behind NAT
NN46110-500
30, before roaming the client was connected via access point 1 (AP1)