Coemar CF 1200 Hard Edge Instruction Manual page 18

4) Press the + or - button; the display will show ccW (for counterclockwise).
function display
5) Press the enter button after either step 3 or 4 to confirm your choice of direction.
oPto
This function allows the sensors which read the instantaneous pan and tilt positions
of the fixture to be switched on or off.
With the sensors activated (opto ON) the projector will automatically return to its
correct position in case it is accidentaly moved out of position.
With the sensors deactivated (opto OFF) the projector will not return automatically
to its correct position if it is accidentaly moved out of position.
NOTE: there will be a noticeable difference in the projector at startup; with opto
ON the reset procedure will take but a few seconds; the reset can last up to a minu-
te with the opto oFF.
1) Press the menu button.
2) Press the + or - button until the display shows oPto
function display
3) Press the enter button to confirm your selection; the display will show on (opto
activated).
function display
4) Press the + or - button; the display will show oFF (opto deactivated).
function display
5) Press the enter button after either step 3 or 4 to confirm your choice.
N.B. We recommend that the opto be deactivated only if it is obviously defective
and requires replacement.