Coemar CF 1200 Hard Edge Instruction Manual page 14

9. Powering up
After having followed the preceding steps, turn on the DMX 512 controller which
will be used to control the CF 1200 Hard Edge. Following this, turn on the
power to the projector, and turn on the projector's power switch. The projector
will perform a reset function on all the internal and external motors.
This will last some few seconds, aftr which it will be subject to the
external signal from the controller.
power
240V
main setting
coemar:
208V
230V
240V
user:
208V
230V
240V
DMX led
The DMX led will be static on to indicate that DMX 512 signal is being correctly
received by the projector.
function display
+
If the led is off, the projector is not receiving signal. check the cabling and the func-
tioning of the controller.
Fuse replacement
Locate the fuse, which protects the lamp and electronics, in the base of the CF
1200 Hard Edge.
Using a multimeter, test the condition of the fuse, replacing it with one of equivalent
type if necessary.
serial number
Set dmx 512 address
T 2A @ 230V
A001 to A493
function display
T 15A @ 230V
menu enter
carefully before i
dmx 512
enter
20 channels per unit
DMX
in
DMX
Wa
Electronic balla
of the neutra