Table of Contents
Advertisement
11. Display panel
functions
The display panel at the rear of the CF 1200 Hard Edge is used to display and set
function information and various parameters.
Altering the coemar factory settings may vary the functioning of the projector, cau-
sing it to not respond to external DMX 512 signal. Please read and familiarise your-
self with the following information very carefully before altering any selections.
reset
This function causes a reset to occur in the case (however unlikely) that one or more
of the motors should lose its reference point.
1) Press the menu button.
2) Press the + or - button until the display shows rESE (for reset).
function display
3) Press the enter button to confirm your selection; all the motors will perform a
reset.
rate
This function provides information on the speed or rate of DMX 512 signal being
received by the CF 1200 Hard Edge.
1) Press the menu button.
2) Press the + or - button until the display shows rAtE (for rate/speed).
function display
3) Press the enter button to confirm your selection; il display visualizza un valore
numerico che è la velocità di trasmissione del segnale DMX 512.
hour
Permette di visualizzare la vita del proiettore, ovvero il numero di ore nelle quali CF
1200 Hard Edge è stato alimentato.
1) Press the menu button.
2) Press the + or - button until the display shows HoUr (per ore).
function display
3) Press the enter button to confirm your selection; the display will show a numeri-
cal value which is the rate/speed of the DMX 512 signal being received.
life
This function provides information on the number of hours of operation of the lamp
in the unit.
1) Press the menu button.
2) Press the + or - button until the display shows LIFE (for lamp life).
function display
3) Press the enter button to confirm your selection; the display will show a numeri-
cal value which is the length of time in hours that the lamp has been operated
since the counter was last reset.
Advertisement
Table of Contents
