Destinations - Mercedes-Benz COMAND Operating Instructions Manual

Destination entry
58
The intermediate stops are listed according
to increasing distance from the current
vehicle position.
i
For intermediate stops that are not
located along the calculated route, the
linear distance is shown.
If COMAND does not find any destinations,
you will see a message to this effect.
Confirm OK by pressing the 9 button.
X
Select a different category.
X
Select the intermediate stop using the
X
9: buttons and press the 9 button
to confirm.
The address entry menu appears, showing
the destination address.
To start route calculation: select
X
and press the 9 button to confirm.
Entering another destination as an
intermediate stop
To switch to navigation mode: press the
X
Ø function button.
To show the menu: press the 9 button.
X
Select Destination
X
menu bar using the :=;
buttons and press the 9 button to confirm.
Select Stopover
X
to confirm.
Select Other.
X
Select Address
X
From Last Destinations
Start
in the navigation
and press the 9 button
Entry, From Memory,
or From POIs.
Selection
Address Entry
From Memory
From Last

Destinations

From POIs
To start route calculation: once you have
X
entered a destination, select
press the 9 button to confirm.
Deleting an intermediate stop
If an intermediate stop has already been
entered, you can delete it.
To switch to navigation mode: press the
X
Ø function button.
To show the menu: press the 9 button.
X
Select Destination
X
menu bar using the =;:
buttons and press the 9 button to confirm.
Select Stopover and press the 9 button
X
to confirm.
Select Delete Stopover
X
9 button to confirm.
COMAND deletes the intermediate stop
and recalculates the route to the main
destination.
Step
Enter a
X
destination by
address
( page 48).
Y
Select a
X
destination from
the destination
memory
( page 54).
Y
Select a
X
destination from
the list of last
destinations
( page 55).
Y
Enter a point of
X
interest
( page 60).
Y
Start and
in the navigation
and press the